Description:

Pressure filters, change-over series DA 2215 are suitable for operating pressure up to 20 bar.
Pressure peaks can be absorbed with a sufficient margin of safety.
Change-over ball valve which, integrated in the middle of the housing, makes it possible to switch from the dirty filter-side to the clean filter-side without interrupting operation.
The filter element consists of star-shaped, pleated filter material which is supported on the inside by a perforated core tube and is bonded to the end caps with a high-quality adhesive. The flow direction is from outside to the inside.
These filters can be installed as suction filters.
For cleaning (see special leaflet 21070-4 and 34448-4) the mesh element respectively to change the glass fibre element remove the cover and take out the element.
Filter finer than 40 μm should use throw-away elements made of paper or Interpor fleece (glass fibre). Filter elements as fine as 5μm(c) are available; finer filter elements on request.
INTERNORMEN-Filter elements are known as elements with a high intrinsicstability and an excellent filtration capability, a high dirt retaining capacity and a long service life.
INTERNORMEN-Filter are suitable for all petroleum based fluids, HW-emulsions, most synthetic hydraulic fluids and lubrication oils.
The inspection according to TÜV, according to ASME VIII Div. 1and the major „Shipyard Classification Societies“ D.N.V.; B.V.; G.L.; L.R.S.; R.I.N.A.; A.B.S. and others are possible. If inspection is required please indicate in your order.

 

 

visual-electrical AE

visual-electrical OE

visual OP

visual AOR/AOC

electronical VS1

electronical VS2